You will need to use event averaging to obtain a low-noise display Connect channel 1 of the scope to show this analog input waveform, and connect channel 2 to show the output voltage of the sample-and-hold stage, labeled "S/H OUT." Trigger from channel 1. Set the FG for a 100-mVpp 50-Hz triangle wave with a 100-mV dc offset. If the supply voltage is 220V-240V, then the RMS voltage values of an AC are also 220V-240V, which is equivalent to the power of DC voltage.
This gives the effective voltage value and it is denoted by Veff or Ieff. That means the power delivered to the load of a DC is equivalent to the RMS voltages of a sine wave (AC signal).Your report should include a derivation of the result for the triangle wave (see the. This is defined as S"v2(t)dt Vrms = (3) т For a sine wave, Vrms = V/V2, and for a triangle wave, Vrms = 10/13. (so that the peak to peak value is PPV = 2V) can be specified in terms of a root-mean-square (RMS) value. Transcribed image text: The magnitude of a periodically varying voltage whose amplitude is V.However, for non-symmetrical waveforms (such as pulse trains) there is a DC voltage content, which is rejected by Agilent's AC-coupled true rms measurements. As seen in the figure above for sine waves, triangle waves, and square waves, the AC-coupled and AC+DC values are equal, because these waveforms do not contain a DC offset.